It is possible to drive plug-in controls from CV signal or an audio feed.
Audio feed is achieved by first enabling an audio capture device via 'Externals -> Audio In' section. You can also jump to this section by clicking on the AF (Audio Feed) tab.
In the picture above is an example of an audio capture device which has been turned on. When turned on any signal levels are displayed in the stereo monitor bars in the AF tab. There are also 4 frequency filter points, Low, LowMid, HighMid, High, in the image above the HighMid filter has spiked. The sensitivity of these filters is controlled by the sliders shown.
You can then assigned the audio as a parameter driver via the slot macro controls.
You can select the type of driver, from a pop up menu, by clicking on the 'text display area'.
Using the swing and delay options. Its possible to produce a Saw Tooth > Triangle Wave > Sine Wave > Pulse effects with this.
The all other controls, from the 'Inv' (Inverse) toggle, effect the value with the result displayed at the end.